![]() ![]() But if I take them out and drop them on the ground, I can't figure out how to pick them up and put them in the kebal's stock inventory. The only place I can store spares is in KAS containers. I can remove the EVA widget or parachute from inventory in the VAB and load up some repair kits, (though I *also* can't figure out how to drop the existing stuff in EVA) but I can't figure out how to get them into inventory when outside of it. The part I'm stuck with is I can't even get it into the kerbal's stock inventory, at least in the field. I may have to actually boot into the game to figure this out. ![]() I hope this helps, but ask me again if not. ![]() To repair something once repair packs are in your kerbals inventory you need to right click on the part to be repaired and the option shows up if the kerbal is close enough. When moving between inventories it helps to pin open the PAWs, even in the VAB. Items should highlight in green if they can be dropped or red if not. To begin with click-drag is the KIS version of moving between inventories the stock version uses click-move. Wow I forgot about this thread, and it has been awhile since I last played KSP1, but I'll see if I can help. What on earth am I doing wrong? How do I drop and pick up things using stock inventory? I'm at a total loss here, and I'm sure I will feel very silly when I'm told the answer. Anything I do in the part list closes the menu that shows the seat inventory. I also can't figure out how to get it into stock inventory in the VAB. There is no right-click option, and dragging does nothing. If I take out the kerbal's stock inventory items in the VAB/ SPH and then launch, I have a free inventory slot, but I can't figure out how to pick up and use the repair kit. On the ground (nearby or far away), on a pod, whatever. If I single click the item, it then moves with my cursor, but I can't get clicking anywhere to do anything. Clicking on the ground near or far or on parts does nothing. ![]() If I click and drag out of the stock inventory, I get the standard KAS interface for dropping/attaching a part, but I can't get it to drop. I'm trying to follow the instructions here, but I can't figure out how to get my Kerbal to drop the things already filling up their stock inventory (parachute and EVA jetpack). I get the difference between the KAS inventory and the stock inventory. I have KAS installed, but am trying to use repair kits, like the OP. Not sure if reviving this thread after all this time is the correct thing to do, but it's the only place where I've been able to find this being discussed. There aren't any tutorials I can find on Youtube, and nothing really fits the bill in the forums. I also can not add it to my stock inventory.too big. However, I find no way to move it from my mother ship to the target some 200 meters away. I have it in the KIS inventory, I can "pull" it out and get the pop up menu of "rotate, attach to node, drop" etc. Now.would you like to go 2 for 2? I also have a mission to attach a "mite" rocket to a satellite. You were spot on, and although I couldn't figure out how to swap the KIS repair kits into stock while "docked" with the satellite, I did return to Kerbin, and refly the mission with the kit in my stock inventory. If this is in orbit you can put the parachute in the pod the kerbal came up with to make room for the repair kits. It is not possible to switch an item from KIS inventory to stock inventory unless the item is placed down somewhere. They need to be in the kerbal's stock inventory which normally contains the parachute and EVA jetpack which can be removed from the kerbal. It sounds like you are using KIS and have the repair kits in the engineer's KIS inventory. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |